Back to Beemers…
I’m working on a project bike for a friend and had the items powder coated satin black. I’m very excited to see how this bike will turn out.
And yes, I have a very messy garage/workbench at the moment.
I removed the wheel bearings and the races with lots of heat, and the help of a press.
Then went to the powder coat shop and gave them the masking instructions.
Here are some photos of the install.
Not pictured is the process of checking and testing the bearings in the race to make sure they spin smoothly.
If not, clean them, re-test, and clean them again, etc…
Then grease ’em good!
Also not pictured is the process of cleaning the inside of the hub REALLY well. Especially since they were sand blasted.
And.. then there is the process of pre-loading the bearings, freezing them for a day, heating the hub and then ‘plop’, you are done.